Take The Furniture Out of The Furniture Mould

  • At the beginning of the injection cycle, the Furniture Mould(FURNITUREMOULD) impression contains air that should be expelled as it moves through the incoming melt. Insufficient ventilation can result in strong compression and heating of trapped air, resulting in the slow filling, poor soldering, and possible burning of polyester resin.


    The vent is located behind the moving path and is usually located within the parting line, but also near the ram. The vents should be large enough to allow air to pass through but avoid melting.


    Furniture mould cooling


    The heat required to remove heat from the assembly to freeze it and cool it under its softening can be demolded. It is important to quickly remove heat for rapid cycling and to evenly avoid warpage associated with uneven crystallization. In multi-cavity moulds, the cooling should be uniform in most components. The moulded heat is manipulated by circulating cold water through a pipe in the furniture mould. The cooling tube should be carefully placed in a plastic mould to ensure uniform cooling of the assembly.


    Due to shear heating, or in its place, a "hot spot" may be encountered at a location near the entrance. This furniture mould happens to be difficult to reach with a cooling tube. Specific metal inserts can be used at these locations, made of polymers with higher heat exchange rates, including tantalum brass. Separate cooling channels can also be fixed at these locations to operate or reduce hot cooling water at a greater rate of movement than the rest of the mould.


    Ejector method


    Many forces should be applied to the moulded parts to eject them from the mould. A mechanized knock-out device comprising a pin or sleeve can be utilized to drive through the movement of the mould when the mould is opened. For mechanized injectors, the area of ??the contact member from the knockout device must be large enough to prevent damage or compression of the component. When constructing the part and the mould, it should be combined with the wall taper to assist the part to be ejected.


    Click Air Cooler Mould to learn about more information.

4 views